IS F V8-5.0L (2UR-GSE) (2008)
(b) Install the transmission control switch to the shift lever guide housing.
NOTICE: Securely engage the claws.
(c) Install the shift lever guide housing with the shift lever lock pin and a new shift lever support.
NOTICE:
-
Install the shift lever nut and lock pin after first engaging the 2 claws.
-
Securely engage the claws.
(d) Connect the transmission control switch connector to the floor shift assembly.
2. INSTALL TRANSMISSION FLOOR SHIFT ASSEMBLY See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Shifter
A/T/Service and Repair/Shift Lever/Installation
3. INSTALL FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY See: Transmission and Drivetrain/Automatic
Transmission/Transaxle/Shifter A/T/Service and Repair/Shift Lever/Installation
4. ADJUST SHIFT LEVER POSITION See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Shifter A/T/Adjustments
5. INSTALL FRONT NO. 1 FLOOR HEAT INSULATOR See: Transmission and Drivetrain/Drive/Propeller Shafts, Bearings and
Joints/Drive/Propeller Shaft/Service and Repair/Installation
6. INSTALL FRONT EXHAUST PIPE ASSEMBLY See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Pipe/Service and
Repair/Installation
7. CONNECT HEATED OXYGEN SENSOR See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Pipe/Service and Repair/Installation
8. INSTALL FRONT CENTER FLOOR BRACE See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Pipe/Service and Repair/Installation
9. INSTALL REAR NO. 1 FLOOR PANEL BRACE See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Pipe/Service and
Repair/Installation