LS 430 V8-4.3L (3UZ-FE) (2002)
6. INSTALL EXTENSION HOUSING REAR OIL SEAL
a. Coat the lip of a new oil seal with MP grease.
b. Using SST and a hammer, drive in the oil seal with the lip facing downward.
SST 09309-37010
Oil seal depth from flat end: 2.0 mm (0.079 inch)
7. INSTALL TRANSMISSION OUTPUT FLANGE
a. Using SST and a hammer, drive in a new oil seal.
SST 09950-60010 (09951-00350), 09950-70010 (09951-07100)
b. Install the output flange.
c. Using a 30 mm deeper socket wrench, install and torque a new nut.
Torque: 126 Nm (1,280 kgf-cm, 92 ft. lbs.)
HINT: Shift the shift lever to P position.
d. Using a chisel and hammer, stake the nut.
8. INSTALL PROPELLER SHAFT
9. INSTALL FRONT EXHAUST PIPE AND HEAT INSULATOR
10. FILL AND CHECK FLUID LEVEL