LS 460 V8-4.6L (1UR-FSE) (2007)
b. Pinch the tip of the tape to make it easier to insert it into the sensor installation hole of the bumper cover.
Check if there is clearance between the sensor tape and sensor installation hole.
HINT: If there is no clearance, adjust it by decreasing the number of times the tape is wrapped. If there is excessive clearance, adjust it by
increasing the number of times the tape is wrapped.
6. APPLY PRIMER
a. Cover the sensor installation hole with protective tape cut to a square with a length/width of 25 mm (0.98 in.).