LS 460 V8-4.6L (1UR-FSE) (2007)
3. The door inner belt seal assembly has four metal clips that engage the metal flange of the door inner panel.
At the top of the rear 3 of the 4 clips a piece of foam is inserted to prevent noise from metal to metal contact.
These foam pieces are NOT glued in place so the foam pieces can fall out when the door inner trim panel is removed.
When reassembling the door inner belt seal assembly to the door panel check that the foam pieces are in place. If NOT insert NEW pieces.
Foam Dimensions: 5 x 5 x 25 mm (0.20 x 0.20 x 0.98 in.)
The door belt inner glass seal can be installed incorrectly causing a gap at the front end of the door glass run at the belt (near A-pillar).
Make sure that the inner glass seal is sitting on the outside of the door glass run.
NOTE
Figure 48 shows the glass seal installed incorrectly.