LS 460 V8-4.6L (1UR-FSE) (2007)
Start by installing the I-shaped spacer piece from the top of the fender as shown.
NOTE
^
When fully installed, the top of the I-shaped spacer should be parallel with the edge of the windshield.
^
Adhesive should be attached to fender.
2. Pull the adhesive backing paper off after the I-shaped spacer is correctly positioned.
Figure 41 shows the position of the I-shaped spacer after installation behind the fender.
Step G: Add EPT foam to outside door panel near base of A-pillar.
Add EPT foam to outside door panel near base of A-pillar.
Foam Dimensions: 5 x 10 x 50 mm (0.20 x 0.40 x 1.97 in.)
1. Attach EPT foam to the door panel sheet metal. The location is at the front triangle area (behind where the chrome molding is normally located).