LS 460 V8-4.6L (1UR-FSE) (2007)
and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery
terminal.
2. REMOVE INSTRUMENT PANEL FINISH END PANEL LH
3. REMOVE STEERING COLUMN COVER
4. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY
5. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
6. REMOVE INSTRUMENT SIDE PANEL LH
7. REMOVE NO. 1 INSTRUMENT CLUSTER MOULDING
8. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
9. REMOVE OUTER MIRROR SWITCH ASSEMBLY
a. Using a screwdriver, detach the 4 claws.
HINT: Tape the screwdriver tip before use.
b. Remove the switch and then disconnect the switch connector.
INSTALLATION
HINT: A bolt without a torque specification is shown in the standard bolt chart.
1. INSTALL OUTER MIRROR SWITCH ASSEMBLY
a. Attach the 4 claws to install the switch.
b. Connect the switch connector.
2. INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
3. INSTALL NO. 1 INSTRUMENT CLUSTER MOULDING
4. INSTALL INSTRUMENT SIDE PANEL LH
5. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY