LS 460 V8-4.6L (1UR-FSE) (2007)
3. Partially remove the roof drip side finish molding.
NOTICE
^
Be careful when removing the molding.
^
Protect the painted surfaces by applying masking tape during repair procedure.
^
Move the bottom of the molding out from behind the fender and hood.
^
Wrap the tip of the molding temporarily with a piece of cloth to protect the vehicle paint from damage.
4. Push on the retaining clips on the molding to release the white clips (one-time use). Install 4 NEW clips to the A-pillar (NOT to the molding).
5. Attach EPT foam at the front of the roof drip side finish molding.
NOTE
^
The front surface of the EPT foam MUST be aligned 30 mm (1.18 in.) from the cutout section in the molding.
^
Align the foam so that the foam top surface is touching the bottom surface of the painted section of the molding.
Step F: Add EPT foam under fender at base of A-pillar.
1. Add I-shaped spacer under the fender at the base of the A-pillar.