LS 460 V8-4.6L (1UR-FSE) (2007)
b. for RH:
1. Install the sensor clamp (labeled B) with the bolt (labeled C).
Torque: 8.5 N.m (87 kgf.cm, 75 in.lbf)
2. Connect the pad wear indicator connector (labeled D).
c. Install the 2 sensor clamps (labeled E) with the 2 bolts (labeled F).
Torque: 8.5 N.m (87 kgf.cm, 75 in.lbf)
NOTE: Do not twist the sensor wire when installing the clamps.
d. Install the sensor clamp (labeled G) with the bolt (labeled H).
Torque: 8.5 N.m (87 kgf.cm, 75 in.lbf)
NOTE: Do not twist the sensor wire when installing the clamp.
e. Attach the sensor clip (labeled I).
f.
Connect the sensor connector (labeled J).
g. Connect the front fender liner.
7. INSTALL FRONT WHEEL