lexus Workshop Repair Guides

Lexus Workshop Service and Repair Manuals

Brake Hose/Line|Front|Page 7182 > < Brake Fluid Level Sensor/Switch|Locations
Page 1
background image

Brake Hose/Line: Service and Repair
Front

FRONT BRAKE FLEXIBLE HOSE

COMPONENTS

REMOVAL

NOTICE:  While the battery is connected, even if the engine switch is off, the brake control system activates when the brake pedal is depressed or the
door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal and open/ close the doors
while the battery is connected.

HINT:
^

Use the same procedures for the LH side and RH side.

^

The procedures listed below are for the LH side.

1. REMOVE COWL TOP VENTILATOR LOUVER RH
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:  Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt
pretensioner activation.

NOTICE:  After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of
memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-)
battery terminal.

3. REMOVE FRONT WHEEL
4. DRAIN BRAKE FLUID

NOTICE:  Wash brake fluid off immediately if it is spilled on any painted surface.

Brake Hose/Line|Front|Page 7182 > < Brake Fluid Level Sensor/Switch|Locations