LS 460 V8-4.6L (1UR-FSE) (2007)
Torque: 4.1 N.m (42 kgf.cm, 36 in.lbf)
2. INSTALL COOLER CONDENSER ASSEMBLY
a. Install the cooler condenser with the 4 bolts.
Torque: 5.0 N.m (51 kgf.cm, 44 in.lbf)
3. CONNECT LIQUID TUBE SUB-ASSEMBLY
a. Remove the attached vinyl tape from the pipe and the connecting part of the cooler condenser.
b. Sufficiently apply compressor oil to a new O-ring and the fitting surface of the pipe joint.
Compressor oil: ND-OIL 8 or equivalent
c. Install the O-ring to the cooler refrigerant liquid pipe.
d. Install the cooler refrigerant liquid pipe to the cooler condenser with the bolt.
Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf)
NOTE:
-
When tightening the bolt, do not allow any tools to contact the pipe.
-
When tightening the bolt, hold a part of the pipe near the connector.
4. CONNECT DISCHARGE HOSE SUB-ASSEMBLY
a. Remove the attached vinyl tape from the hose and the connecting part of the cooler condenser.
b. Sufficiently apply compressor oil to a new O-ring and the fitting surface of the hose joint.