LS 460 V8-4.6L (1UR-FSE) (2007)
Alignment: Service and Repair
Rear Wheel Alignment
REAR WHEEL ALIGNMENT
ADJUSTMENT
1. INSPECT TIRE
(a)
Inspect the tires.
2. MEASURE VEHICLE HEIGHT
(a)
Measure the vehicle height for coil suspension.
(b) Measure the vehicle height for air suspension.
3. INSPECT TOE-IN
Standard toe-in: B - A 3 ± 2 mm (0.12 ± 0.08 in.)
If the toe-in is not within the specified range, inspect the suspension parts and replace if necessary.
4. ADJUST TOE-IN
(a)
Loosen the toe adjust cam nut.
(b) Turn the adjust cams by an equal amount to adjust toe-in.
HINT:
^
Try to adjust the toe-in to the center value.
^
The toe-in will change by the following specification corresponding to each graduation of the cam: Approximately: 4.8 mm (0.19 in.)
(c)
Tighten the nut.
Torque: 60 N*m (612 kgf*cm, 44 ft.*lbf)
5. INSPECT CAMBER
(a)
Install a camber-caster-kingpin gauge or put the wheels on a wheel alignment tester.
(b) Inspect the camber.