LS 460 V8-4.6L (1UR-FSE) (2007)
5. Connect the red clip of SST to the battery positive (+) terminal and the black clip of SST to the battery negative (-) terminal.
f.
Deploy the airbag.
1. Check that no one is inside the vehicle or within a 10 m (33 ft.) radius of the vehicle.
2. Press the SST activation switch and deploy the airbag.
CAUTION:
-
When deploying the airbag, make sure that no one is near the vehicle.
-
The driver side knee airbag becomes extremely hot when the airbag is deployed, so do not touch it for at least 30 minutes after
deployment.
-
Use gloves and safety glasses when handling a driver side knee airbag with a deployed airbag.
-
Do not apply water to a driver side knee airbag with a deployed airbag.
-
Always wash your hands with water after completing the operation.
HINT: The airbag is deployed as the LED of the SST activation switch comes on.
2. DISPOSE OF DRIVER SIDE KNEE AIRBAG ASSEMBLY (WHEN NOT INSTALLED IN VEHICLE)
NOTE: Be sure to follow the procedure detailed below when deploying the airbag.
HINT: Prepare a battery as the power source to deploy the airbag.
a. Check the function of SST.
b. Remove the driver side knee airbag.
CAUTION:
-
When removing the driver side knee airbag, work must be started 90 seconds after the engine switch is turned off and the negative
(-) terminal cable is disconnected from the battery.
-
When storing the driver side knee airbag, keep the airbag deployment side facing upward.