lexus Workshop Repair Guides

Lexus Workshop Service and Repair Manuals

SRS Service Tips|Page 10177 > < SRS Service Tips|Page 10175
Page 5
background image

a. Perform a diagnostic system check.
b. With the front seat side airbag removed from the vehicle, perform a visual check. If there are any defects as mentioned below, replace the front

seat side airbag with a new one:
-

Cuts, minute cracks or marked discoloration on the front seat side airbag.

-

Cracks or other damage to the wire harness or connector.

NOTE:  For removal and installation procedures of the front seat side airbag, be sure to follow the correct procedure.

Rear Airbag Sensor

ON-VEHICLE INSPECTION

1. CHECK REAR AIRBAG SENSOR (VEHICLE NOT INVOLVED IN COLLISION)

a. Perform a diagnostic system check.

2. CHECK REAR AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED)

a. Perform a diagnostic system check.
b. When the quarter panel of the vehicle or its area is damaged, check if there is any damage to the rear airbag sensor. If there are any defects as

mentioned below, replace the rear airbag sensor with a new one:
-

Cracks, dents or chips on the sensor housing.

-

Cracks or other damage to the connector.

-

Peeling off of the label or damage to the serial number.

CAUTION:  For removal and installation procedures of the rear airbag sensor, be sure to follow the correct procedure.

3. CHECK REAR AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG IS DEPLOYED)

a. Replace the rear airbag sensor.

CAUTION:  For removal and installation procedures of the rear airbag sensor, be sure to follow the correct procedure.

HINT:  The rear airbag sensor on the impacted side should be replaced after the curtain shield airbag has deployed.

Rear Seat Side Airbag Assembly

ON-VEHICLE INSPECTION

1. CHECK REAR SEAT SIDE AIRBAG ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION)

a. Perform a diagnostic system check.
b. With the rear seat side airbag installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the rear seat

with a new one:
Cuts, minute cracks or marked discoloration on the rear seatback around the rear seat side airbag.

2. CHECK REAR SEAT SIDE AIRBAG ASSEMBLY (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED)

SRS Service Tips|Page 10177 > < SRS Service Tips|Page 10175