LS 460 V8-4.6L (1UR-FSE) (2007)
d. Remove the height control sensor.
NOTE: Do not drop the height control sensor. If it is dropped, replace it with a new one.
INSTALLATION
HINT:
-
Use the same procedures for the RH side and LH side.
-
The procedures listed are the LH side.
1. INSTALL HEIGHT CONTROL SENSOR SUB-ASSEMBLY FRONT LH
a. Install the height control sensor with the 2 bolts.
Torque: 13.5 N.m (138 kgf.cm, 10 ft.lbf)
NOTE: Do not drop the height control sensor.If it is dropped, replace it with a new one.
b. Connect the height control sensor link to the lower arm with the bolt.
Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf)
c. Connect the connector and attach the 2 clips.
2. INSTALL FRONT WHEEL
Torque: 140 N.m (1428 kgf.cm, 103 ft.lbf)
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
4. INSTALL COWL TOP VENTILATOR LOUVER RH