LS 460 V8-4.6L (1UR-FSE) (2007)
(d) Temporarily install the control shaft lever.
(e)
Turn the control shaft lever counterclockwise until it stops, and then turn it clockwise 2 notches to set it to the N position.
(f)
Remove the control shaft lever.
(g) Align the groove with the neutral basic line.
(h) Hold the switch in this position and tighten the bolt.
Torque: 13 N*m (133 kgf*cm, 10 ft.*lbf)
(i)
Using a screwdriver, bend the tabs of the lock washer.
HINT: Bend at least 2 washer tabs.