LS 460 V8-4.6L (1UR-FSE) (2007)
/Page-1190013.png)
CAUTION:
^
As the rear differential carrier assembly (with drive shaft) is very heavy, securely support it with the transmission jack.
^
Perform this procedure with several people supporting the rear differential carrier assembly (with drive shaft) so that it does
not tilt or fall.
(b) Using SST or a 12 mm socket hexagon wrench, remove the 3 bolts (A) from the rear No. 1 and No. 2 differential mount cushions.
SST 09249-63010
(c)
Remove the 2 bolts (B).
(d) Slowly lower the transmission jack. Then remove the rear differential mount stopper upper and lower, and rear differential carrier assembly
from the rear suspension member.
NOTICE:
^
Do not drop the rear differential carrier assembly (with drive shaft).
^
When removing the rear differential carrier assembly (with drive shaft), do not damage the installation surface.
54. REMOVE REAR SUSPENSION MEMBER SUB-ASSEMBLY
(a)
Support the rear suspension member with an engine lift and attachments.
CAUTION:
^
As the rear differential carrier assembly (with drive shaft) is very heavy, securely support it with the transmission jack.
^
Perform this procedure with several people supporting the rear differential carrier assembly (with drive shaft) so that it does
not tilt or fall.
(b) Removing the parking brake actuator harness and release cable.
(1) Disconnect the trunk interior's parking brake actuator grommet and connector.
(2) Remove the clamps shown in the illustration.
