LS 460 V8-4.6L (1UR-FSE) (2007)
/Page-1207013.png)
(f)
Temporarily install the 2 bolts with the adjusting washers.
HINT: Use the adjusting washers which were removed.
2. TIGHTEN NO. 1 CENTER SUPPORT BEARING ASSEMBLY
(a)
Adjust the dimension between the edge surface of the center support bearing and the edge surface of the cushion to 11.5 to 13.5 mm (0.452
to 0.531 in.) as shown in the illustration.
(b) Check that the center line of the bracket is at a right angle to the shaft axial direction.
(c)
Tighten the 2 bolts.
Torque: 49 N*m (500 kgf*cm, 36 ft.*lbf)
