LS 460 V8-4.6L (1UR-FSE) (2007)
NOTE
^
Only 3 of the 7 rivets need to be drilled out (numbers 2, 4, & 5 in Figure 19). Drill out the 3 rivets that do NOT have a pink paint mark next
to the rivet.
(1) Wrap tape around a 4 mm (0.157 in.) drill bit.
(2) Lightly press the drill against the rivet and drill off the rivet's flange.
NOTICE
^
Pressing the drill too firmly will cause the rivet to turn and result in the rivet NOT being drilled through.
^
Do NOT pry the rivet with the drill, because this may cause damage to the installation holes of the rivet or the drill bit.
(3) Using a vacuum cleaner remove the rivet fragments and shavings from the drilled area.
Remove the two screws at the rear edge of the door frame.