LS 460 AWD V8-4.6L (1UR-FSE) (2009)
(3) Connect the pad wear indicator connector.
(c) Install the 2 sensor clamps with the 2 bolts.
Torque: 8.5 Nm (87 kgf-cm, 75 in-lbf)
NOTE:
Do not twist the sensor wire when installing the clamps.
(d) Attach the 2 sensor clips.
NOTE:
When installing the clips, do not twist the wire harness.
(e) Connect the sensor connector.
(f) Connect the front fender liner.
3. INSTALL FRONT WHEEL
Torque: 140 Nm (1428 kgf-cm, 103 ft-lbf)
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and Inspection/Programming
and Relearning/Repair Instruction - Initialization.
5. INSTALL COWL TOP VENTILATOR LOUVER RH See: Wiper and Washer Systems/Wiper Motor/Service and Repair/Installation
6. CHECK SPEED SENSOR SIGNAL
(a) Check the speed sensor signal See: Testing and Inspection/Component Tests and General Diagnostics/Test Mode Procedure.