LS 460 AWD V8-4.6L (1UR-FSE) (2009)
(c) Install the brake booster pump bush (labeled C) and a new brake actuator bracket clamp (labeled D) to the brake accumulator pump.
NOTE:
Make sure to securely insert the brake accumulator pump until the claws of the clamp are attached.
3. INSTALL NO. 4 BRAKE ACTUATOR BRACKET
(a) Install the No. 4 brake actuator bracket to the brake actuator with the bolt.
Torque: 18 Nm (184 kgf-cm, 13 ft-lbf)
4. CONNECT BRAKE ACCUMULATOR PUMP CONNECTOR BOX
(a) Connect the brake accumulator pump connector box as follows:
(1) Install the connector box with the nut (labeled A).
Torque: 6.0 Nm (61 kgf-cm, 53 in-lbf)
(2) Attach the wiring harness clamp (labeled B).
5. INSTALL NO. 3 BRAKE ACTUATOR TUBE
NOTICE:
-
Do not damage the No. 3 brake actuator tube, brake actuator and brake accumulator pump.
-
When installing the No. 3 brake actuator tube, hold the tube, brake actuator and brake accumulator pump securely.
-
When tightening the nut, make sure that other parts do not move with the nut.