LS 460 AWD V8-4.6L (1UR-FSE) (2009)
Cruise Control Switch: Service and Repair
Installation
CRUISE CONTROL: CRUISE CONTROL MAIN SWITCH: INSTALLATION
INSTALLATION
1. INSTALL CRUISE CONTROL MAIN SWITCH ASSEMBLY
(a) Install the switch.
(b) Install the 2 screws.
(c) Connect the connector and clamp.
2. INSTALL STEERING PAD See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Steering Pad/Installation
3. INSTALL SWITCH AND VOLUME CASE See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Steering Pad/Installation
4. INSTALL NO. 2 STEERING WHEEL COVER LOWER See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Steering
Pad/Installation
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
6. REMOVE COWL TOP VENTILATOR LOUVER LH See: Starting and Charging/Charging System/Alternator/Service and Repair/Installation
7. PERFORM INITIALIZATION
(a) Perform initialization See: Testing and Inspection/Programming and Relearning/Repair Instruction - Initialization.
NOTE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
8. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light See: Restraint Systems/Air Bag Systems/Testing and Inspection/Initial Inspection and Diagnostic
Overview/Diagnosis System.