LS 460 AWD V8-4.6L (1UR-FSE) (2009)
1. INSTALL CAMSHAFT TIMING CONTROL WITH EDU MOTOR ASSEMBLY LH
(a) Turn the camshaft timing gear's intermediate shaft index slot in the counterclockwise direction by hand, and set it to the maximum retard angle
position.
-
When the cam of the camshaft lifts the valve, the intermediate shaft becomes difficult to turn.
-
The position where the intermediate shaft stops is the maximum retard angle.
(b) Install a new O-ring to the timing chain cover.
(c) Align the joint of the camshaft timing control with EDU motor and the keyway of the camshaft timing gear, and install the motor with the 3
bolts.
Torque: 21 Nm (214 kgf-cm, 15 ft-lbf)
-
Do not allow foreign matter to contact the oil seal face of the camshaft timing control with EDU motor (connecting surface with timing
chain cover).
-
When installing the camshaft timing control with EDU motor, do not use excessive force.
-
Do not drop the camshaft timing control with EDU motor. If dropped, replace it.
-
Do not disassemble the camshaft timing control with EDU motor. If disassembled, replace it.
-
Check that [L] is printed on the label of the camshaft timing control with EDU motor.
-
When installing the camshaft timing control with EDU motor, be sure to align the timing chain cover knock pin with the camshaft timing
control with EDU motor pin hole.
-
Install the camshaft timing control with EDU motor with the arrow facing upward.
(d) Connect the 2 camshaft timing control with EDU motor connectors and engine wire clamp.
2. INSTALL CAMSHAFT TIMING CONTROL WITH EDU MOTOR ASSEMBLY RH
(a) Turn the camshaft timing gear's intermediate shaft index slot in the counterclockwise direction by hand, and set it to the maximum retard angle