LS 460 AWD V8-4.6L (1UR-FSE) (2009)
/Page-1042007.png)
(a) Install the cover with the 3 hole seals and 4 grommets.
14. INSTALL REAR FLOOR SIDE MEMBER COVER RH
(a) Install the cover with the clip, nut, 3 bolts and 2 screws.
Torque: 5.4 Nm (55 kgf-cm, 48 in-lbf)
15. REMOVE REAR FLOOR SIDE MEMBER COVER LH
(a) Install the cover with the clip, nut, 3 bolts and 2 screws.
Torque: 5.4 Nm (55 kgf-cm, 48 in-lbf)
16. INSTALL NO. 5 ROCKER PANEL MOULDING PROTECTOR
(a) Install the protector with the 2 clips and screw.
17. INSTALL NO. 6 ROCKER PANEL MOULDING PROTECTOR
(a) Install the protector with the 2 clips and screw.
18. INSTALL NO. 1 DIFFERENTIAL SUPPORT PROTECTOR See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft
Assembly/Service and Repair/Removal and Replacement/Rear Drive Shaft Assembly/Installation
19. INSTALL NO. 2 DIFFERENTIAL SUPPORT PROTECTOR See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft
Assembly/Service and Repair/Removal and Replacement/Rear Drive Shaft Assembly/Installation
