LS 460 AWD V8-4.6L (1UR-FSE) (2009)
Battery Current Sensor: Service and Repair
Installation
POWER SOURCE / WIRING: BATTERY CURRENT SENSOR: INSTALLATION
INSTALLATION
1. INSTALL BATTERY CURRENT SENSOR
(a) Insert the hook of the ground terminal through the battery current sensor's hole. Then attach the hook to the parts labeled A of the bracket.
(b) Hook the bracket onto the hole on the engine room body, and install the battery current sensor assembly with the bolt.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
(c) Connect the connector to the battery current sensor assembly.
2. INSTALL FRONT FENDER PROTECTOR UPPER RH See: Wiper and Washer Systems/Wiper Motor/Service and Repair/Installation
3. INSTALL ENGINE ROOM SIDE COVER RH See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and
Replacement/Engine/Installation
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
5. INSTALL COWL TOP VENTILATOR LOUVER RH See: Starting and Charging/Charging System/Alternator/Service and Repair/Installation
6. PERFORM INITIALIZATION
(a) Perform initialization See: Testing and Inspection/Programming and Relearning/Repair Instruction - Initialization.
NOTE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.