LS 460 AWD V8-4.6L (1UR-FSE) (2009)
(c) Remove the 4 bolts.
(d) Detach the clip and remove the driver side knee airbag.
(e) Disconnect the connector.
NOTE:
When handling the airbag connector, take care not to damage the airbag wire harness.
Installation
SUPPLEMENTAL RESTRAINT SYSTEM: DRIVER SIDE KNEE AIRBAG ASSEMBLY: INSTALLATION
INSTALLATION
1. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY
(a) Connect the connector.
NOTE:
When handling the airbag connector, take care not to damage the airbag wire harness.
(b) Attach the clip to install the driver side knee airbag.
(c) Install the 4 bolts.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
(d) Attach the claw to install the lock lever.
(e) Install the control cable.
2. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Installation
3. INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Installation
4. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Installation
5. INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY See: Sensors and Switches/Sensors and Switches - Wiper and Washer Systems/Wiper
Switch/Service and Repair/Installation
6. INSTALL STEERING COLUMN COVER (W/O Driver Monitor Camera) See: Steering and Suspension/Steering/Steering Column/Service and
Repair/Removal and Replacement/Steering Column Assembly (W/ VGRS)/Installation
7. INSTALL STEERING COLUMN COVER (W/ Driver Monitor Camera) See: Steering and Suspension/Steering/Steering Column/Service and
Repair/Removal and Replacement/Steering Column Assembly (W/ VGRS)/Installation
8. INSTALL NO. 1 INSTRUMENT CLUSTER MOULDING See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service
and Repair/Installation
9. INSTALL INSTRUMENT SIDE PANEL LH See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Installation
10. INSTALL INSTRUMENT PANEL FINISH PANEL END LH See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Installation
11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
12. PERFORM INITIALIZATION
(a) Perform initialization See: Testing and Inspection/Programming and Relearning/Initialization.
NOTE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
13. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light See: Testing and Inspection/Programming and Relearning/Initialization.