LS 460 AWD V8-4.6L (1UR-FSE) (2009)
/Page-2658008.png)
(e) Remove the 2 bolts and seat belt.
Installation
SEAT BELT: FRONT SEAT OUTER BELT ASSEMBLY: INSTALLATION
INSTALLATION
HINT:
-
Use the same procedures for the LH side and RH side.
-
The procedures listed below are for the LH side.
-
A bolt without a torque specification is shown in the standard bolt chart See: Specifications/Mechanical Specifications/Standard Bolt -
Specified Torque For Standard Bolts.
1. INSTALL FRONT SEAT OUTER BELT ASSEMBLY
NOTE:
When installing the retractor, make sure the vehicle's claws (labeled "a" in the illustration) only contact the installation areas of the retractor.
(a) Align the vehicle's claws with the seat belt retractor positioning holes.
(b) Install the seat belt with the 2 bolts. First install the upper bolt, and then install the lower bolt.
Torque: 7.5 Nm (76 kgf-cm, 66 in-lbf)for bolt A
Torque: 42 Nm (428 kgf-cm, 31 ft-lbf)for bolt B
(c) Connect the pretensioner connector labeled A, as shown in the illustration.
(d) Connect the tension reducer connector labeled B.
(e) W/ Pre-collision system:
Connect the pre-collision connector labeled C.
