LS 460 AWD V8-4.6L (1UR-FSE) (2009)
SUPPLEMENTAL RESTRAINT SYSTEM: SIDE AIRBAG SENSOR: REMOVAL
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt
pretensioner activation.
2. REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH
(a) Remove the front seat outer belt See: Seat Belt Systems/Seat Belt/Service and Repair/Front Seat Outer Belt Assembly/Removal.
3. REMOVE FRONT SEAT BELT RETRACTOR COVER LH
(a) Disengage the claw and remove the front seat belt retractor cover from the body.
4. REMOVE SIDE AIRBAG SENSOR ASSEMBLY LH
(a) Remove the bolt and side airbag sensor from the body.
(b) Disconnect the connector.
Installation
SUPPLEMENTAL RESTRAINT SYSTEM: SIDE AIRBAG SENSOR: INSTALLATION
INSTALLATION
1. INSTALL SIDE AIRBAG SENSOR ASSEMBLY LH
(a) Check that the engine switch is off.
(b) Check that the cable is disconnected from the battery negative (-) terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt
pretensioner activation.
(c) Install the side airbag sensor with the bolt.
Torque: 9.0 Nm (92 kgf-cm, 80 in-lbf)
NOTICE: