LS 460 AWD V8-4.6L (1UR-FSE) (2009)
/Page-238008.png)
NOTICE:
-
Wrap masking tape so that there is no clearance between the sensor and tape, as shown in the illustration.
-
Wrap the tape so that it has no wrinkles.
HINT: To make the tape application easier, lightly fold the tape so that it is roughly the shape of the sensor.
(2) Pinch the tip of the tape to make it easier to insert it into the sensor installation hole of the bumper cover.
(3) Check if there is clearance between the sensor tape and sensor installation hole.
HINT: If there is no clearance, adjust it by decreasing the number of times the tape is wrapped. If there is excessive clearance, adjust it by
increasing the number of times the tape is wrapped.
(b) Apply primer.
(1) Cover the sensor installation hole with protective tape cut to a square with a length/ width of 25 mm (0.98 in.).
(2) Using a brush or felt, apply primer or equivalent to the retainer installation area.
NOTICE:
-
Use a clean brush or felt.
