LS 460 AWD V8-4.6L (1UR-FSE) (2009)
/Page-575001.png)
Crankshaft Position Sensor: Testing and Inspection
1UR-FSE ENGINE CONTROL SYSTEM: CRANKSHAFT POSITION SENSOR: ON-VEHICLE INSPECTION
ON-VEHICLE INSPECTION
1. CHECK CRANKSHAFT POSITION SENSOR OUTPUT VOLTAGE
(a) Turn the engine switch on (IG).
(b) Measure the voltage according to the value(s) in the table below.
Standard voltage:
(c) While turning the crankshaft pulley by hand, measure the voltage between each terminal. Check that the voltage changes between the Hi range
and Lo range shown in the table below.
Standard voltage:
