LS 460 AWD V8-4.6L (1UR-FSE) (2009)
/Page-633004.png)
(e) Turn the control shaft lever counterclockwise until it stops, and then turn it clockwise 2 notches to set it to the N position.
(f) Remove the control shaft lever.
(g) Align the groove with the neutral basic line.
(h) Hold the switch in this position and tighten the bolt.
Torque: 13 Nm (133 kgf-cm, 10 ft-lbf)
(i) Using a screwdriver, bend the tabs of the lock washer.
HINT: Bend at least 2 washer tabs.
(j) Install the transmission control shaft lever with the spring washer and nut.
Torque: 16 Nm (163 kgf-cm, 12 ft-lbf)
(k) Connect the switch connector.
2. CONNECT FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY
(a) Temporarily connect the shifting rod to the connecting rod swivel with the nut.
HINT: The nut will be tightened to a torque specification during the shift lever position adjustment procedure.
