LS 460 AWD V8-4.6L (1UR-FSE) (2009)
AA80F AUTOMATIC TRANSMISSION: PARK / NEUTRAL POSITION SWITCH: REMOVAL
REMOVAL
1. REMOVE COWL TOP VENTILATOR LOUVER See: Starting and Charging/Charging System/Alternator/Service and Repair/Removal
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
-
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
-
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and
settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery
terminal.
3. REMOVE FRONT EXHAUST PIPE ASSEMBLY
(a) Remove the front exhaust pipe See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Pipe/Service and Repair/Removal.
4. REMOVE FRONT FLOOR NO. 1 HEAT INSULATOR See: Transmission and Drivetrain/Drive/Propeller Shafts, Bearings and
Joints/Drive/Propeller Shaft/Service and Repair/Removal and Replacement/Propeller Shaft Assembly/Removal
5. DISCONNECT FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY
(a) Remove the nut and disconnect the floor shift gear shifting rod.
6. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY
(a) Disconnect the switch connector.
(b) Remove the nut, spring washer and transmission control shaft lever.
(c) Using a screwdriver, bend the tabs of the lock washer.