LS 460 AWD V8-4.6L (1UR-FSE) (2009)
/Page-634004.png)
(d) Temporarily install the control shaft lever.
(e) Turn the control shaft lever counterclockwise until it stops, and then turn it clockwise 2 notches to set it to the N position.
(f) Remove the control shaft lever.
(g) Align the neutral basic line with the groove.
(h) Hold the switch in position and tighten the bolt.
Torque: 13 Nm (130 kgf-cm, 9 ft-lbf)
(i) Using a screwdriver, bend the tabs of the lock washer.
HINT: Bend at least 2 washer tabs.
(j) Install the transmission control shaft lever and spring washer with the nut.
Torque: 16 Nm (160 kgf-cm, 12 ft-lbf)
(k) Connect the switch connector.
