LS 460 AWD V8-4.6L (1UR-FSE) (2009)
/Page-1671076.png)
(a) Remove the differential carrier from the overhaul attachment.
44. INSTALL REAR DIFFERENTIAL BREATHER PLUG OIL DEFLECTOR
(a) Clean the seal packing attached on the differential carrier and carrier cover using a scraper and wire brush. Then remove the oil with a
non-residue solvent or equivalent.
NOTE:
Do not scratch the fitting surface.
(b) Install the rear differential breather plug oil deflector to the rear differential carrier cover with the bolt.
Torque: 7.0 Nm (72 kgf-cm, 62 in-lbf)
45. INSTALL REAR DIFFERENTIAL CARRIER COVER
(a) Apply seal packing to the differential carrier as shown in the illustration.
Seal packing:
Toyota Genuine Seal Packing 1281, Three bond 1281 or equivalent
NOTICE:
-
Apply the seal packing in a continuous line, approximately 2 to 3 mm (0.08 to 0.12 in.) in diameter.
-
Overlap the seal packing at least 10 mm at the beginning and the end of application.
-
Install the differential carrier cover within 3 minutes of application.
(b) Install the differential carrier cover with the 8 bolts.
Torque: 47 Nm (475 kgf-cm, 35 ft-lbf)
NOTE:
Do not fill the oil or drive immediately after installing the differential carrier cover. Leave the vehicle for at least 1 hour. Also, avoid sudden
acceleration and deceleration for at least 72 hours after application.
46. INSTALL REAR DIFFERENTIAL CARRIER COVER BREATHER PLUG
