LS 460 AWD V8-4.6L (1UR-FSE) (2009)
(a) Hold the drive shaft lightly in a soft vise.
(b) Install the outboard joint boot clamp onto the boot.
(c) Place SST onto the outboard joint boot clamp.
SST: 09521-24010
(d) Tighten SST so that the outboard joint boot clamp is pinched.
NOTE:
Do not overtighten SST.
(e) Using SST, measure the clearance of the outboard joint boot clamp.
SST: 09240-00020
Clearance:
1.2 to 4.0 mm (0.0472 to 0.157 in.)
NOTE:
When the measured value is greater than the specified value, retighten the clamp.
7. INSTALL FRONT NO. 2 AXLE OUTBOARD JOINT BOOT CLAMP RH
HINT: Use the same procedures described for the LH side.
8. INSTALL FRONT DRIVE SHAFT DAMPER RH
(a) Install the drive shaft damper to the drive shaft.
(b) Make sure that the damper is on the shaft groove.
(c) Set the distance as specified below.
Distance:
226 to 230 mm (8.90 to 9.06 in.)
(d) Using a screwdriver, install a new drive shaft damper clamp as shown in the illustration.