LS 460 AWD V8-4.6L (1UR-FSE) (2009)
/Page-3676003.png)
-
Allow the primer to dry for 3 minutes or more.
-
Do not apply primer to the adhesive.
-
Throw away any leftover primer.
-
Do not apply too much primer.
(b) Using a brush or sponge, apply Primer G to the contact surface of the back window glass.
Standard measurement:
HINT: If primer is applied to an area that is not specified, wipe off the primer with a non-residue solvent before it dries.
NOTICE:
-
Allow the primer to dry for 3 minutes or more.
-
Throw away any leftover primer.
-
Do not apply too much primer.
(c) Apply adhesive to the back window glass.
Adhesive:
Toyota Genuine Windshield Glass Adhesive or equivalent
(1) Cut off the tip of the cartridge nozzle as shown in the illustration below.
HINT: After cutting off the tip, use all adhesive within the time written in the table below.
Usage time frame:
(2) Load the sealer gun with the cartridge.
(3) Apply adhesive to the back window glass as shown in the illustration.