LS 460 RWD V8-4.6L (1UR-FSE) (2010)
(3) If the bubble is not within the red frame, use a hexagon wrench to adjust bolt A until the air bubble is within the red frame.
HINT
*
The adjustable range within the level's red frame is +/-0.2°
*
The target angle is +0.2° (upward angle of 0.2°).
(d) Adjust the reflector height.
(1) Adjust the reflector so that the center of the SST reflector is the same height as the millimeter wave radar sensor.
SST : 09870-60000
09870-60010
SST : 09870-60040
HINT
Prepare a 10 m (32.8 ft.) string with a sharp-pointed weight (plumb bob) and a 5 m (16.4 ft.) tape measure.
(e) Place the reflector.
(1) Hang the string (with weight) from the center of the vehicle rear's emblem. Mark the vehicle rear's center point on the ground. Repeat for
the front of the vehicle.
(2) Set one end of the 10 m (32.8 ft.) string on the vehicle rear's center point. Run the string over the vehicle front's center point to a position 5
m (16.4 ft.) beyond the vehicle front's center point, as shown in the illustration. Mark the 5 m (16.4 ft.) position.
(3) Using a tape measure, measure 15.1 mm (0.594 in.) to the left of the 5 m (16.4 ft.) position. Place the reflector at that position.
NOTICE:
Perform the operation as precisely as possible.