LS 460 RWD V8-4.6L (1UR-FSE) (2010)
/Page-3005013.png)
(b) Disconnect the connector.
(c) Remove the 2 bolts and detach the claw. Then remove the module.
Installation
SEAT: SEAT VIBRATOR MODULE ASSEMBLY (for Ottoman): INSTALLATION
HINT
A bolt without a torque specification is shown in the standard bolt chart See: Specifications/Mechanical Specifications/Standard
Bolt - Specified Torque For Standard Bolts.
1. INSTALL SEAT VIBRATOR MODULE ASSEMBLY
(a) Attach the claw and install the module with the 2 bolts.
Torque : 9.8 Nm (100 kgf-cm, 87 in-lbf)
(b) Connect the connector.
(c) Connect the air hose connector.
2. INSTALL LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY RH See: Doors, Hood and Trunk/Trunk / Liftgate/Trunk / Liftgate
Spring/Service and Repair/Installation
3. INSTALL LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY LH See: Doors, Hood and Trunk/Trunk / Liftgate/Trunk / Liftgate
Spring/Service and Repair/Installation
4. INSTALL REAR FLOOR FINISH PLATE See: Doors, Hood and Trunk/Trunk / Liftgate/Trunk / Liftgate Spring/Service and Repair/Installation
5. INSTALL TOOL BOX (w/o Spare Tire)
6. INSTALL DECK BOARD ASSEMBLY (w/o Spare Tire)
7. INSTALL FRONT LUGGAGE COMPARTMENT TRIM COVER See: Doors, Hood and Trunk/Trunk / Liftgate/Trunk / Liftgate
