lexus Workshop Repair Guides

Lexus Workshop Service and Repair Manuals

Front Brake Flexible Hose|Page 5777 > < Brake Fluid Level Sensor/Switch|Locations|Page 5772
Page 1
background image

Brake Hose/Line: Service and Repair
Front Brake Flexible Hose

Components

BRAKE: FRONT BRAKE FLEXIBLE HOSE: COMPONENTS

Removal

BRAKE: FRONT BRAKE FLEXIBLE HOSE: REMOVAL

NOTICE:
While the battery is connected, even if the engine switch is off, the brake control system activates when the brake pedal is depressed or
the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal and
open/close the doors while the battery is connected.

HINT
*

Use the same procedure for the RH and LH sides.

*

The procedure listed below is for the LH side.

1. REMOVE COWL TOP VENTILATOR LOUVER RH   See: Wiper and Washer Systems/Wiper Motor/Service and Repair/Removal

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
*

w/ Navigation System (for HDD):

*

records various types of memory and settings. As a result, after turning the engine switch off, be sure to wait for the time specified
in the following table before disconnecting the cable from the negative (-) battery terminal.

Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal:

Front Brake Flexible Hose|Page 5777 > < Brake Fluid Level Sensor/Switch|Locations|Page 5772