LS 460 RWD V8-4.6L (1UR-FSE) (2010)
/Page-1739006.png)
Installation
BRAKE CONTROL: REAR SPEED SENSOR: INSTALLATION
NOTICE:
While the battery is connected, even if the engine switch is off, the brake control system activates when the brake pedal is depressed or
the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal and
open/close the doors while the battery is connected.
HINT
*
The procedures listed below are for the RH side.
*
Other than areas where instructions are provided, use the same procedures for the LH side and RH side.
1. INSTALL REAR SPEED SENSOR RH
(a) Install the sensor with the bolt.
Torque : 8.5 Nm (87 kgf-cm, 75 in-lbf)
NOTICE:
*
The rear speed sensor is easily damaged. When installing the rear speed sensor to the rear axle hub RH, do not use excessive force
to rotate and install it.
*
Prevent foreign matter from attaching to the sensor tip.
*
Do not drop the sensor. If the sensor has been dropped, replace the sensor with a new one.
2. INSTALL SKID CONTROL SENSOR WIRE
(a) Connect the connector to the rear speed sensor.
(b) Install the sensor clamp with the bolt.
Torque : 8.5 Nm (87 kgf-cm, 75 in-lbf)
NOTICE:
Do not twist the sensor wire when installing the clamps.
(c) Connect the pad wear indicator connector.
(d) Install the sensor clamp with the nut.
Torque : 5.5 Nm (56 kgf-cm, 49 in-lbf)