LS 460 RWD V8-4.6L (1UR-FSE) (2010)
Do not reuse the 4 removed nuts.
HINT
During installation, hold the front exhaust pipe.
(d) Install the front exhaust pipe to the tailpipe LH and RH with the 4 bolts.
Torque : 39 Nm (398 kgf-cm, 29 ft-lbf)
HINT
During installation, hold the front exhaust pipe.
7. INSTALL FRONT FLOOR CENTER BRACE
(a) Install the brace with the 4 bolts.
Torque : 7.4 Nm (75 kgf-cm, 65 in-lbf)
8. CONNECT HEATED OXYGEN SENSOR (for 2WD)
NOTICE:
Do not strike the metal part of the sensor.
(a) Rotate the sensors counterclockwise the same number of times as recorded in the removal procedure, and install then to the front exhaust pipe
by hand.
NOTICE:
After rotating the sensor counterclockwise the same number of times as the removal procedure, install it while making sure that the
wire harness is not twisted.
(b) Using SST, tighten the 2 sensors.
with SST - Torque : 40 Nm (408 kgf-cm, 30 ft-lbf)
without SST - Torque : 44 Nm (449 kgf-cm, 32 ft-lbf)