LS 460 RWD V8-4.6L (1UR-FSE) (2010)
(a) Install the cooler condenser with the 4 bolts.
Torque : 5.0 Nm (51 kgf-cm, 44 in-lbf)
3. CONNECT LIQUID TUBE SUB-ASSEMBLY
(a) Remove the attached vinyl tape from the tube and the connecting part of the cooler condenser.
(b) Sufficiently apply compressor oil to a new O-ring and the fitting surface of the tube joint.
Compressor oil:
ND-OIL 8 or equivalent
(c) Install the O-ring to the cooler refrigerant liquid tube.
(d) Install the cooler refrigerant liquid tube to the cooler condenser with the bolt.
Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)
NOTICE:
*
When tightening the bolt, do not allow any tools to contact the tube.
*
When tightening the bolt, hold a part of the tube near the connector.
4. CONNECT DISCHARGE HOSE SUB-ASSEMBLY