LS 460 RWD V8-4.6L (1UR-FSE) (2010)
Headlamp Alignment Control Module: Service and Repair
Removal
LIGHTING: AFS ECU: REMOVAL
1. REMOVE COWL TOP VENTILATOR LOUVER RH See: Starting and Charging/Charging System/Alternator/Service and Repair/Removal and
Replacement/Removal
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt
pretensioner activation.
NOTICE:
*
w/ Navigation System (for HDD):
*
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of
memory and settings. As a result, after turning the engine switch off, be sure to wait for the time specified in the following table
before disconnecting the cable from the negative (-) battery terminal.
Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal:
*
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning.
3. REMOVE FRONT DOOR SCUFF PLATE RH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Roof Headlining (for Standard Body)/Removal
4. REMOVE COWL SIDE TRIM BOARD RH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Roof Headlining (for Standard Body)/Removal
5. REMOVE AFS ECU
(a) Disconnect the connector and clamp.
(b) Remove the 3 nuts and AFS ECU.