LS 460 RWD V8-4.6L (1UR-FSE) (2010)
Techstream Preparation
Selecting the TIS Techstream VIM or the Mongoose MFC VIM.
Techstream software requires a VIM selection before you can use the Mongoose MFC VIM.
If using TIS Techstream no changes are needed.
Perform the following:
1. Select Setup from the Techstream Main Menu screen.
2. Select VIM Select from the Setup drop down menu.
3. Select the correct Interface Setup from the drop down list.
If using Techstream Lite select Mongoose MFC.
NOTE
Mongoose MFC Software and Driver MUST be installed before Mongoose MFC selection will be available.
See TIS - Diagnostics - Scantool page for additional information.
If using TIS Techstream select TIS Techstream VIM (this is the default).
4. Click OK.
Operation Procedure
1. Verify the vehicle's applicability for recalibration and locate desired calibration file.
A. Connect Techstream and establish a vehicle connection.