LS 460 RWD V8-4.6L (1UR-FSE) (2010)
![background image](/lexus/ls_460_rwd/v8-4.6l_(1ur-fse)/Page-366007.png)
NOTICE:
Do not twist the sensor wire when installing the clamps.
(e) Except for coil spring type suspension:
(1) Install the sensor clamp (labeled A) with the nut (labeled B).
Torque : 5.5 Nm (56 kgf-cm, 49 in-lbf)
(2) Connect the rear height control sensor connector (labeled C).
(f) Insert the connector and grommet to the inside of the vehicle through the hole in the wheel house.
(g) for RH:
(1) Connect the rear speed sensor wire connector.
(h) for LH:
(1) Install the No. 1 skid control sensor clamp with the nut.
Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)
(2) Attach the skid control sensor wire.
(3) Connect the sensor connector.
3. INSTALL REAR WHEEL See: Steering and Suspension/Suspension/Suspension Strut / Shock Absorber/Service and Repair/Removal and
Replacement/Rear Shock Absorber (w/ Air Suspension)/Installation
4. INSTALL LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY RH See: Body and Frame/Doors, Hood and Trunk/Trunk /
Liftgate/Trunk / Liftgate Spring/Service and Repair/Installation
5. INSTALL LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY LH See: Body and Frame/Doors, Hood and Trunk/Trunk /