LS 460 RWD V8-4.6L (1UR-FSE) (2010)
(d) Connect the harness to the +B terminal with the nut.
Torque : 12 Nm (122 kgf-cm, 9 ft-lbf)
2. INSTALL V-RIBBED BELT See: Engine, Cooling and Exhaust/Engine/Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service and
Repair/Installation
3. INSTALL INTAKE AIR CONNECTOR PIPE See: Powertrain Management/Fuel Delivery and Air Induction/Throttle Body/Service and
Repair/Installation
4. INSTALL NO. 2 ENGINE UNDER COVER See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and
Replacement/Engine/Installation
5. INSTALL FRONT SUSPENSION MEMBER PROTECTOR LOWER See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal
and Replacement/Engine/Installation
6. INSTALL NO. 1 ENGINE UNDER COVER See: Engine, Cooling and Exhaust/Cooling System/Coolant/Service and Repair
7. INSTALL NO. 1 AIR CLEANER INLET See: Powertrain Management/Fuel Delivery and Air Induction/Throttle Body/Service and
Repair/Installation
8. INSTALL AIR CLEANER INLET COVER SUB-ASSEMBLY See: Powertrain Management/Fuel Delivery and Air Induction/Throttle
Body/Service and Repair/Installation
9. INSTALL V-BANK COVER SUB-ASSEMBLY See: Powertrain Management/Fuel Delivery and Air Induction/Throttle Body/Service and
Repair/Installation
10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
11. INSTALL COWL TOP VENTILATOR LOUVER RH
(a) Install the 6 clips and cowl top ventilator louver RH.
NOTICE:
If the cowl top ventilator louver RH is not properly installed, water may leak into the engine room and cause malfunctions. Therefore,
make sure the cowl top ventilator louver RH is installed properly.
12. PERFORM INITIALIZATION
(a) Perform initialization See: Testing and Inspection/Programming and Relearning.
NOTICE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.