LS 460 RWD V8-4.6L (1UR-FSE) (2010)
(b) Install a new cotter pin.
4. CONNECT TIE ROD ASSEMBLY RH
HINT
Use the same procedures described for the LH side.
5. CONNECT NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY (for AWD) See: Steering Column/Service and Repair/Removal and
Replacement/Steering Column Assembly (W/ VGRS)/Installation
6. CONNECT NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY (for 2WD) See: Steering Column/Service and Repair/Removal and
Replacement/Steering Column Assembly (W/ VGRS)/Installation
7. INSTALL FRONT NO. 1 STABILIZER BAR BUSH (for AWD) See: Suspension/Stabilizer Bar/Service and Repair/Front Stabilizer
Bar/Installation
8. INSTALL FRONT STABILIZER BAR (for AWD) See: Suspension/Stabilizer Bar/Service and Repair/Front Stabilizer Bar/Installation
9. INSTALL FRONT NO. 1 STABILIZER BRACKET LH (for AWD) See: Suspension/Stabilizer Bar/Service and Repair/Front Stabilizer
Bar/Installation
10. INSTALL FRONT NO. 1 STABILIZER BRACKET RH (for AWD) See: Suspension/Stabilizer Bar/Service and Repair/Front Stabilizer
Bar/Installation
11. INSTALL NO. 2 FRONT STABILIZER BRACKET RH (for AWD)
(a) Install the bracket and bolt.
Torque : 22 Nm (224 kgf-cm, 16 ft-lbf)
(b) Connect the 2 clamps.
12. INSTALL FRONT SUSPENSION MEMBER BRACKET SUB-ASSEMBLY RH (for AWD)
(a) Install the bracket with the 4 bolts.
Torque : 50 Nm (510 kgf-cm, 37 ft-lbf)
13. INSTALL FRONT SUSPENSION MEMBER BRACKET SUB-ASSEMBLY LH (for AWD)