LS 460 RWD V8-4.6L (1UR-FSE) (2010)
NOTICE:
*
Do not damage the dust cover of the No. 2 lower arm.
*
As the dust cover may be damaged, adjust SST with the center nut so that the body and crow are parallel.
*
Make sure to tie the string of SST to the vehicle, to prevent SST from dropping.
(f) Remove the bolt and nut, and then remove the No. 2 suspension lower arm LH.
Installation
SUSPENSION: FRONT LOWER SUSPENSION ARM (for 2WD): INSTALLATION
HINT
*
Use the same procedures for the RH side and LH side.
*
The procedures listed below are for the LH side.
*
A bolt without a torque specification is shown in the standard bolt chart See: Specifications/Mechanical Specifications/Standard
Bolt - Specified Torque For Standard Bolts.
1. TEMPORARILY TIGHTEN FRONT NO. 2 SUSPENSION LOWER ARM ASSEMBLY LH
(a) Insert the bolt from the front of the vehicle. Then temporarily install the front No. 2 suspension lower arm LH with the nut.
HINT
Tighten the nut after the vehicle is stabilized.
(b) Temporarily install the front No. 2 suspension lower arm LH to the steering knuckle with the nut.