LS 460 RWD V8-4.6L (1UR-FSE) (2010)
Compressor/Pump: Service and Repair
Installation
SUSPENSION CONTROL: HEIGHT CONTROL COMPRESSOR: INSTALLATION
1. INSTALL HEIGHT CONTROL COMPRESSOR
(a) Install the 3 bushings and bracket to the height control compressor with the 3 bolts.
Torque : 5.9 Nm (60 kgf-cm, 52 in-lbf)
(b) Push the connector into the housing until a clicking sound is heard.
(c) Attach the 3 clamps.
(d) Install the height control sensor with the bolt and 2 nuts.
Torque : 19.1 Nm (195 kgf-cm, 14 ft-lbf)
(e) Connect the height control tube See: Service Precautions/Suspension Control System.
(f) Connect the height control filter to the bumper reinforcement.
(g) Connect the 2 connectors and attach the 2 clamps.
2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
3. INSTALL COWL TOP VENTILATOR LOUVER RH See: Starting and Charging/Charging System/Alternator/Service and Repair/Removal and
Replacement/Installation
4. PERFORM INITIALIZATION
(a) Perform initialization See: Testing and Inspection/Programming and Relearning.
NOTICE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.