LS 460 RWD V8-4.6L (1UR-FSE) (2010)
Inspection/Programming and Relearning.
*
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of
memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from
the negative (-) battery terminal.
3. REMOVE CONSOLE BOX ASSEMBLY
(a) Remove the console box See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal and Replacement/Front
Console Box (w/o Rear Seat Entertainment System)/Removal.
4. REMOVE NO. 1 CONSOLE BOX DUCT
(a) Remove the 2 screws and pull out the duct to remove it.
5. REMOVE FRONT EXHAUST PIPE ASSEMBLY
(a) Remove the front exhaust pipe See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Pipe/Service and Repair/Removal.
6. REMOVE FRONT FLOOR NO. 1 HEAT INSULATOR See: Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller Shaft/Service and
Repair/Removal and Replacement/Removal
7. DISCONNECT FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY
(a) Move the shift lever to N.
(b) Remove the nut and disconnect the shifting rod from the connecting rod swivel.
8. REMOVE TRANSMISSION FLOOR SHIFT ASSEMBLY
(a) Disconnect the 2 connectors.
(b) Detach the 6 wire harness clamps from the floor shift.
(c) Remove the 4 bolts and floor shift.
Installation
AA80F AUTOMATIC TRANSMISSION: FLOOR SHIFT ASSEMBLY: INSTALLATION
HINT
A bolt without a torque specification is shown in the standard bolt chart See: Specifications/Mechanical Specifications/Standard
Bolt - Specified Torque For Standard Bolts.
1. INSTALL TRANSMISSION FLOOR SHIFT ASSEMBLY