LS 460 RWD V8-4.6L (1UR-FSE) (2010)
(e) Temporarily install a new bolt (C).
(f) Using SST and a 12 mm socket hexagon wrench, tighten the 2 bolts (A).
SST : 09249-63010
without SST - Torque : 142 Nm (1450 kgf-cm, 105 ft-lbf)
with SST - Torque : 103 Nm (1054 kgf-cm, 76 ft-lbf)
NOTICE:
*
Use a torque wrench with a fulcrum length of 400 mm (16 in.)
*
Tighten the bolts so that they do not interfere with the bolt holes of the mount cushions.
(g) Using SST and a 12 mm socket hexagon wrench, tighten the bolt (C).
SST : 09249-63010
without SST - Torque : 142 Nm (1450 kgf-cm, 105 ft-lbf)
with SST - Torque : 103 Nm (1054 kgf-cm, 76 ft-lbf)
NOTICE:
*
Use a torque wrench with a fulcrum length of 400 mm (16 in.)
*
Tighten the bolts so that they do not interfere with the bolt holes of the mount cushions.
(h) Tighten the 2 bolts (B).
Torque : 127 Nm (1300 kgf-cm, 94 ft-lbf)
NOTICE:
Make sure that the mount stop upper and lower are not shifted or tilted.
2. INSTALL REAR DRIVE SHAFT ASSEMBLY RH
(a) Install the rear drive shaft assembly See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Installation.
3. INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
(a) Install the rear propeller with center bearing shaft assembly See: Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller Shaft/Service
and Repair/Removal and Replacement/Installation.